MEC 1011 - Design Communication I
Chris Campbell’s Electronic Notebook

Vermont Technical College

 

Assignment 1 – Part Documentation

                        Third angle construction

                        First angle construction

Assignment 2 – Basic Features

                        Part 1 - Extrude, Hole, Chamfer, Fillet, Rectangular and Circular Pattern, Revolution, Emboss, Thread, Coil

                        Part 2 - Extrude

                        Part 3 - Extrude, Chamfer, Thread, Hole

                        Part 4 - Coil

                        Part 5 - Extrude, Shell

                        Part 6 - Derived ฝ size

Assignment 3 – Assembly Documentation

                        Donut holder drawing 1

                        Donut holder top

                        Donut holder bottom

                        Donut holder drawing assembly

Assignment 4 – Advanced Features

                        Face Draft

                        Loft

                        Ribs

                        Sweep

                        T with Center Plane

                        T with Diagonal Hole

Assignment 5 – AutoCAD 2-D Modeling

                        Drawing in AutoCAD 1

                        Drawing in AutoCAD 2

Assignment 6 – Part Documentation and Sheet Metal

                        Top electrical cover

                        Base electrical cover

                        Base electrical cover drawing

Assignment 7 – Special Views and Sculpted Forms

                        Base stamp holder – Sculpted feature, section view

                        Base stamp holder drawing

Assignment 8 – Assembly Documentation

                        Donut holder – assembly

                        Base

                        Top

                        Top drawing

                        Bottom drawing

                        Donut holder drawing

                        Dowell pin

Assignment 9 – Electronic Notebooks

Assignment 10 – Presentations

Assignment 11 – Screws and Positional Tolerances

Assignment 12 – AutoCAD Documentation

Challenge 1 –

Challenge 2 –